Install the corner trim on the four corners of the building with the same color coordinated panel screws you used for attaching the exterior panels; those being the #12 x 1 inch screws. Install the screws through the flat flanges at the edges of the trim into each of the wall girts and base rail just like we did for the side wall panels.
Sometimes you’ll need to use two pieces to achieve the total height of the corner, if so, overlap the pieces of corner trim about two to three inches or so and make sure that joint is where a girt is so that the joint is good and secure.
Video Index:
Introduction
1. The foundation
2. Eave or corner brackets
3. Roof & wall assembly
4. Truss assembly
5. Hat channel spacing
6. Base rail assembly
7. Anchoring base rails
8. Wall & roof to base
1. The foundation
2. Eave or corner brackets
3. Roof & wall assembly
4. Truss assembly
5. Hat channel spacing
6. Base rail assembly
7. Anchoring base rails
8. Wall & roof to base
9. Squaring up the frame
10. Install back enclosure
11. Install front enclosure
12. Door & window frame
13. Girts & hat channel
14. Radiant barrier insulation
15. Side exterior panels
16. Gable end panels
10. Install back enclosure
11. Install front enclosure
12. Door & window frame
13. Girts & hat channel
14. Radiant barrier insulation
15. Side exterior panels
16. Gable end panels
17. Door & window trim
18. Corner trim
19. Roof panels
20. Doors & windows
21. Eave trim
22. Gable trim
23. Ridge cap
24. Finishing touches
18. Corner trim
19. Roof panels
20. Doors & windows
21. Eave trim
22. Gable trim
23. Ridge cap
24. Finishing touches